I can see that the location is authorized, but I’m also seeing that the event subscriptions in SmartThings were removed when the location was disconnected.
As a test, can you please try taking one rule that you can easily trigger using a device from SmartThings – for example, maybe a rule triggered by a switch status changing that you can easily control – then do the following:
- Disable the rule and save
- Wait a moment
- Enable the rule and save
- Refresh the page (while on a SharpTools dashboard/rule/user page)
- Wait 30+ seconds for the background healthcheck to complete
- Try testing that rule again.
Edit: I can see that SmartThings is reporting that the Location Mode event subscription is setup now, so I suspect that if you toggle the mode, you should see that change in your dashboard.
Edit2: I updated the instructions above to indicate that you would need to refresh the page to run the healthcheck in the background after disabling and re-enabling the rule.
